Huf Generation 1 RDV Valve Installation Instructions

Fore more information about the Huf Generation 1 RDV Valve Stem, please click here. 
Installation Instructions:
1. Before inserting the valve, please ensure that the valve hole and the surface of the rim are cleaned and even to allow for proper sealing.
2. Insert valve through rim of wheel.
3. Insert metal rod into the side hole on the bottom of the valve beneath the rim lip.
4. Place washer over the top of the valve and then tighten the nut to 4Nm of torque.
5. Take screw and affix the sensor making sure the sensor is in full contact with the rim.
6. Tighten the bottom screw using a hex driver to 4Nm.
7. Install tire on the rim as directed for all TPMS sensors.
8. Tighten the valve cap to complete the process.
Image
157 Viking Ave.
Brea, CA. 92821 
(714) 482-3996 
Advertisements